Unverified83% confidenceDecision RuleTime unknown
自粘型止震板必须先用异丙醇清洁除油、板面加热或用擀轮压实，粘贴前钣金温度低于10℃会导致附着不牢半年后脱落
1
Sources
83%
Confidence
Long-term
Relevance
-
First Seen
Sources
Related Entities
Related Claims
Unverified粘贴前需彻底清洁去油去蜡并保持干燥，温度低于10℃时压敏胶初粘力下降，应在15-30℃环境施工并按压排气，牢固度直接受施工条件影响83% similarUnverified自粘型密封条依赖3M或亚克力背胶，粘贴前必须用酒精彻底除油除尘且表面温度＞10℃，冬季低温直接粘贴粘性下降50%以上，易脱落80% similarUnverified粘贴前需用异丙醇(酒精)清洁去除油脂并保证基材干燥，压敏胶初粘后需静置24-48小时达到最终粘接强度，此期间避免沾水和外力剥离79% similarUnverified3M粘贴式门夹的粘贴面须彻底清洁去油去尘并按压后静置24小时再受力，否则易脱落；冬季低温（低于10℃）粘贴初粘力大幅下降，应用吹风机预热门面或改用物理卡扣款79% similarUnverified所有强力双面胶粘贴前必须清洁并彻底干燥表面，油污灰尘残留会使承重力下降50%以上；粘贴后需按压30秒并静置24-72小时达到终粘力，不可即贴即用重物78% similar
Cite This Claim
Stable URI
https://kongchang.com/claim/122893API
curl https://kongchang.com/api/v1/knowledge/claims/122893MCP
get_claim(id=122893)