Unverified50% confidenceFactExact time
The apex offset deviation of an MPO end face measured by a 3D interferometer is no more than 50 μm; too large an offset pushes up insertion loss and worsens return loss.
1
Sources
50%
Confidence
Long-term
Relevance
10/16/2026
First Seen
Sources
Related Entities
Related Claims
UnverifiedThe radius of curvature of an MPO end face measured by a 3D interferometer should be controlled at 10-25 mm; too small may damage the fiber, while too large will produce an air gap.77% similarUnverifiedThe fiber height of an MPO end face measured by a 3D interferometer should remain within ±50 nm to ensure proper physical contact between mating connectors.71% similarUnverifiedA calibration reprojection error of 1.8 pixels is 3 to 5 times higher than the industry quality standard (0.3–0.5 px) and will be amplified through PnP solving into centimeter-level 3D measurement deviations.68% similar
Cite This Claim
Stable URI
https://kongchang.com/claim/1043282API
curl https://kongchang.com/api/v1/knowledge/claims/1043282MCP
get_claim(id=1043282)